Axis Q1614-E Montageanleitung Seite 18

AXIS Q1614-E Network Camera
Function Pin
1
0 V DC (-)
2
DC output
3–
Configurable
4
(Input or
Output)
Audio Connector
3.5 mm audio
connectors (stereo)
1 Tip
Audio Input Balanced: 'Hot' signal
Microphone/Line in
Unbalanced: Microphone/Line
in
Audio Output
Line out (mono)
RS485/422 Connector
Two 2-pin terminal blocks for RS485/RS422 serial
interface. The serial port can be configured to support:
• Two-wire RS485 half duplex
• Four-wire RS485 full duplex
• Two-wire RS422 simplex
• Four-wire RS422 full duplex point to point
communication
Notes
Can be used to power auxiliary equipment.
Note: This pin can only be used as power out.
Digital input – Connect to pin 1 to activate,
or leave floating (unconnected) to deactivate.
Digital output – Connected to pin 1 when
activated, floating (unconnected) when
deactivated. If used with an inductive load,
e.g. a relay, a diode must be connected in
parallel with the load, for protection against
voltage transients.
3 2 1
2 Ring
Balanced: 'Cold' signal
Microphone/Line in
Unbalanced: Unused
RX/TX
1 2 3
18
Specifications
12 V DC
Max load = 50 mA
0 to max 30 V DC
0 to max 30 V DC, open
drain, 100 mA
3 Sleeve
Ground
Ground
TX
4