Inhaltsverzeichnis
Werbung
TROUBLE! MATERIAL BEING SPRAYED IS SPLATTERING
WHAT'S WRONG?
Viscosity of material is too high.
TROUBLE! ATOMIZATION IS TOO COARSE
WHAT'S WRONG?
Viscosity of material too high.
Flow control knob setting too high
Material accumulated
/clog inside nozzle
Air inlet blocked
Canister loose
Quick refill lid loose
TROUBLE! SPRAYER PULSATES.
WHAT'S WRONG?
Air filter clogged
Material in canister almost empty.
Canister loose
Quick refill lid loose
TROUBLE! SPRAY MATERIAL DOES NOT COVER PROPERLY
WHAT'S WRONG?
Flow control knob setting too low.
Clearance to target area too large
Too few spray paths sprayed over
target area
Viscosity of material too high.
WHAT TO DO...
Thin material per manufacturer
recommendation.
WHAT TO DO...
Thin material per manufacturer
recommendation.
Decrease flow control setting
Clean
Clean or change air filter
Screw canister tightly in place
Screw quick refill lid tight in place
WHAT TO DO...
Clean or change air filter
Refill canister.
Screw canister tightly in place
Screw quick refill lid tight in place
WHAT TO DO...
Increase flow control setting
Reduce spray distance
Apply more spray paths sprayed over target
area
Thin material per manufacturer
recommendation.
- 19-
Werbung
Inhaltsverzeichnis
