Inhaltsverzeichnis
Werbung
To select Vertical Flat Jet, turn the air cap (#5) to horizontal direction by turning the
smartnozzle selector (#3) clockwise until stop.
To select Circular Jet, turn the Spray Width Lever (#8) to the
icon
of Minimum.Note: Spray nozzle can only be assembled in onedirection
that the notch of the nozzle(#6) must align with the skirt on spray unit housing(#10).
Refer toFig. T1 for properassembly
Warning!:
Risk of injury. Never point the sprayer at anypart of the body. Never pull the trigger
while adjusting thespray setting.
ADJUSTING WIDTH OF SPRAY PATTERN (Fig.H1)
By turning the Spray Width Lever (#8) between the Minimum marking and Maximum
marking, the width of the spray patterns can be adjusted accordingly.
FIG. H
Application
Initial coatings,
corners, edges,
and hard to reach
locations
Small-medium
size surface
Spray Width
Lever #8
- 12 -
Air Cap #3
Spray Jet Pattern
Small circular jet
Vertical narrow jet for
horizontal coating
direction Horizontal
narrow jet
Werbung
Inhaltsverzeichnis
