Inhaltsverzeichnis
Werbung
► Do not use materials with a flashpoint higher than60°C ( 140°F) . Flashpoint is the
temperature that afluid can produce enough vapors to ignite (see coatingsupplier).
► Make sure clean up area is well ventilated and free offlammable vapors.
► Always spray outdoors when spraying cleaningsolution through sprayer.
► Do not submerse power unit.
► Use drop cloths during pouring, mixing, and viscositytesting of materials to be
sprayed
to protect yourfloors and anything else in the spraying area that youwish to remain
untouched.
► To begin cleaning:
► Turn the power unit off, unplug the cord anddisconnect air hose from sprayer.
► Unscrew the canister from the sprayer and pourany remaining liquid back into the
original container(Fig. M).
► Pour a small amount of the appropriate cleaningsolution into the canister (Fig. N).
- Warm soapy water for water based materials
- Manufacturers recommended cleaning solution for oilbased materials
► Screw on the canister back to the sprayer securely and vigorouslyshake the sprayer.
► Unscrew the canister and properlydispose of cleaning solution.
► Refill the canister with a small amount of new cleaningsolution (Fig. M). Screw onthe
canister back the sprayer.
► Reattach the air hose to the sprayer, plug in the cordand turn on the power unit.
► Spray the cleaning solution through the sprayer ontoscrap material for 2 to 3 seconds
(Fig. O).
► Turn the power unit off, unplug the cord and disconnectair hose from sprayer.
► Unscrew the canister from the sprayer.
► Remove the o-ring(#14), pickup tube(#15),check valve (#16), andquick refill lid(#12)
from the sprayer.Clean the parts with the cleaning brush in theappropriate cleaning
solution (Fig. P).
Note: When removing the check valve, twist the check valve clockwise and then pull
it out.(Fig P1)
- 15 -
Werbung
Inhaltsverzeichnis
