Inhaltsverzeichnis
Werbung
TROUBLESHOOTING
TROUBLE! MATERIAL RUNS OR DRIPS.
WHAT'S WRONG?
Spraying too much materia
Spraying too slowly.
Spraying too close.
Viscosity too thin.
TROUBLE! MATERIAL DRIPS FROM NOZZLE
WHAT'S WRONG?
Nozzle loose
Nozzle breaks
Y-type seal ring of nozzle breaks
Material accumulated /clog inside
nozzle
TROUBLE! TOO MUCH OVER SPRAY.
WHAT'S WRONG?
Sprayer too far from surface.
Too much material being sprayed.
TROUBLE! LITTLE OR NO MATERIAL BEING RELEASED.
WHAT'S WRONG?
Spray nozzle/tip clogged.
Y-type seal ring of nozzle missing
Pickup tube loose or clogged.
Canister loose
Quick refill lid loose
Air hose split or disconnected
Flow control knob setting too low.
Air inlet blocked
Material too thick.
WHAT TO DO...
Reduce paint flow by turning
material adjustment knob.
Increase speed of application.
Increase distance from surface.
Check dilution recommendation.
WHAT TO DO...
Screw nozzle tight
Change
Change
Clean
WHAT TO DO...
Reduce distance to surface.
Reduce paint flow by turning flow
control knob
WHAT TO DO...
Clean nozzles.
Add seal ring to nozzle and assemble in
place
Check tube.
Screw canister tightly in place
Screw quick refill lid tight in place
Check air hose
Increase flow control setting
Clean or change air filter
Thin material per manufacturer
recommendation
- 18 -
Werbung
Inhaltsverzeichnis
