pewag UNI-MOVE Montage Seite 12

Mounting anti-skid chain with mounting cable
1. Spread out chain in front of or behind the tire and arrange properly. Tension lever,
tension spring and tension chain outward! Put mounting cable at an angle across the
top half of the tire. Hook anti-skid chain into mounting hook.
2. Drive slowly one complete turn of the wheel onto the chain, thereby pulling the chain
onto the tire. Loosen anti-skid chain by unhooking the rings and/or mounting hook.
Remove mounting cable.
3. Connect the Anti-skid chain first on the inside then on the outside of the tire.
4. Connect the attachment links for the tread net.
5.+ The attachment links must be connected so that the flattened section of each part is
5A
in contact with the road. When correctly fitted both flats must be visible.
6. The chain is now properly connected.
7. Tighten tension chain on the outside of the wheel and insert tension lever into the next
link of the tension chain. Secure tension lever with the ring. Hang loose chain end into
the side chain.
Usual quick-assembly without mounting cable
1. Take inner chain, lift chain up, push it backwards and spread evenly over the tire.
2. Drive approx. 1/4 of a wheel's turn onto the chain.
3. Further mounting like mounting with mounting cable, point 3 – 7.
Demounting of anti-skid chains
– Unhook tension spring
– Open tension lever
– Loosen tension chain
– Loosen closing hook (starting on the outside of the wheel)
– Pull chain off of the wheel
E