Specifications - Makita 6833 Bedienungsanleitung

ENGLISH
1-1. Lock button
1-2. Switch trigger
2-1. Reversing switch
3-1. Hook
4-1. Casing
4-2. Thumb screw
5-1. Dust cover
5-2. Plane bearing
5-3. Bit

SPECIFICATIONS

No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For Model 6833
For European countries only
Noise and Vibration
The typical A-weighted sound pressure level is 80 dB (A).
Uncertainty is 3 dB(A).
The noise level under working may exceed 85 dB (A).
Wear ear protection.
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN60745.
For Model 6834
For European countries only
Noise and Vibration
The typical A-weighted sound pressure level is 81 dB (A).
Uncertainty is 3 dB(A).
Explanation of general view
6-1. Lever
6-2. Stopper base
6-3. Plate
6-4. Casing
7-1. Stopper base
7-2. Casing
7-3. Adjusting knob
8-1. Feeder box
8-2. Screw strip
Model
Screw strip
-1
)
Overall length
Net weight
Safety class
2
.
6833
4 mm
x 25 mm - 41 mm
4,700
364 mm
1.9 kg
ENE033-1
The noise level under working may exceed 85 dB (A).
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
ENF002-1
These values have been obtained according to
EN60745.
For Model 6836
For European countries only
Noise and Vibration
The typical A-weighted sound pressure level is 83 dB (A).
Uncertainty is 3 dB(A).
The noise level under working may exceed 85 dB (A).
ENG003-2
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN60745.
Model; 6833,6834,6836
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 89/336/EEC, 98/37/EC.
ENG003-2
000087
4
8-3. Screw guide
9-1. Driving position
11-1. Reverse button
12-1. Extension handle
14-1. Wall
14-2. Stopper base
15-1. Limit mark
16-1. Screwdriver
16-2. Brush holder cap
6834
4 mm
x 25 mm - 57 mm
2,800
396 mm
1.9 kg
/II
Wear ear protection.
2
.
Wear ear protection.
2
.
Yasuhiko Kanzaki CE2005
6836
4 mm
x 25 mm - 41 mm
6,000
364 mm
1.9 kg
ENG003-2
ENH101-5