Preparing Kombimotor For Operation; Assembling The Kombimotor; Mounting The Loop Handle; Mounting And Removing The Barrier Bar - Stihl KMA 130 R Gebrauchsanleitung

5 Preparing KombiMotor for Operation

5 Preparing KombiMotor for Operation
5.1 Preparing KombiMotor for Operation
Perform the following steps before starting work:
► Make sure the following components are in a safe
condition:
– KombiMotor, @ 4.6.
– Mount the KombiTool as described in the instruction
manual supplied with the KombiTool.
– Battery as described in the STIHL AR battery's
instruction manual or in the user instructions for the "AP
belt bag with connecting cable".
► Check the battery as described in the STIHL AR battery's
instruction manual or in the user instructions for the "AP
belt bag with connecting cable".
► Recharge the battery fully as described in the instruction
manual for the STIHL AL 101, 300, 500 chargers.
► Clean the KombiMotor, @ 15.
► Mount the loop handle, @ 6.1.
► If you are using an FS-KM with a metal cutting attachment:
Mount the barrier bar, @ 6.2.1.
► Mount the KombiTool as described in the instruction
manual supplied with the KombiTool.
► Put on and adjust the STIHL AR battery, carrying system
or "AP belt bag with connecting cable", @ 7.
► Adjust the loop handle, @ 7.4.
► Check the controls, @ 10.1.
► If 3 LEDs on the battery flash red while you are checking
the controls: Pull connecting cable plug out of the
socket and contact your STIHL dealer for assistance.
There is a malfunction in the KombiMotor.
► If you cannot carry out these steps: Do not use your
KombiMotor and contact your STIHL servicing dealer for
assistance.
0458-805-9621-A

6 Assembling the KombiMotor

6.1

Mounting the Loop Handle

► Switch off the KombiMotor and pull the connecting cable
plug out of the socket.
1
2
6
7
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the drive tube
(5).
► Fit washers (2) on the screws (1).
► Hold the clamp (6) against the drive tube (5).
► Insert screws (1) through holes in loop handle (3) and
clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
The loop handle must not be removed again.
6.2

Mounting and Removing the Barrier Bar

6.2.1 Mounting Loop Handle with Barrier Bar
► Switch off the KombiMotor and pull the connecting cable
plug out of the socket.
English
3
4
5
35