Parts Description - Makita DCJ205 Betriebsanleitung

PARTS DESCRIPTION

Battery holder (optional accessory)
► Fig.1
1 Battery holder
(10.8 V - 12 V max)
Model CJ105D / DCJ205
► Fig.2
1 Power button
Model CJ106D / DCJ206
► Fig.3
1 Power button
5 Hood
Model CV102D / DCV202
► Fig.4
1 Power button
INSTALLATION
Installing or removing the battery
cartridge
CAUTION:
Always switch off the device
before installing or removing the battery
cartridge.
CAUTION:
Hold the battery holder and the
battery cartridge firmly when installing or remov-
ing the battery cartridge. Failure to hold the battery
holder and the battery cartridge firmly may cause
them to slip out of your hands and result in damage
to the battery holder and battery cartridge and/or a
personal injury.
► Fig.5: 1. Red indicator 2. Button 3. Battery cartridge
4. Battery holder (optional accessory)
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert the battery cartridge all the way until
it locks in place with a small click. If you can see the red
indicator on the upper side of the button, it is not locked
completely.
To remove the battery cartridge, slide it from the battery
holder while pressing the button on the front of the
cartridge.
CAUTION:
Always install the battery car-
tridge fully until the red indicator cannot be seen.
Otherwise the battery cartridge may accidentally
fall out of the battery holder, causing injury to you or
someone around you.
CAUTION:
Do not forcibly install the battery
cartridge. If the battery cartridge does not slide in
easily, it is not being inserted correctly.
2 Battery holder
(14.4 V /18 V)
2 Battery pocket
2 Battery pocket
6 Name tag holder
2 Battery pocket
3 Belt hook
3 Jack
3 Jack
- -
3 Jack
Battery pocket
The battery holder (with battery cartridge) can be stored
in the battery pocket. Connect the power cable jack
pulled out of the battery pocket to the battery holder
plug. Then put the battery holder into the battery pocket
and fasten the fastener.
► Fig.6: 1. Power cable 2. Jack 3. Plug 4. Battery
pocket
The belt hook on the battery holder can be detached by
removing the screws.
► Fig.7: 1. Screw 2. Belt hook
Attaching the battery holder
You can hang the battery holder on your waist belt.
To prevent the battery holder from dropping acciden-
tally, attach a strap using the strap hole and secure it.
1. Pull the power cable out of the upper hole in the
battery pocket and feed the jack through the lower hole
in the battery pocket and pull it through to the inside of
the jacket or vest.
► Fig.8: 1. Power cable 2. Upper hole 3. Battery
pocket 4. Jack 5. Lower hole
2.
Attach the belt hook of the battery holder to your
waist belt, and connect the jack to the battery holder
plug.
► Fig.9: 1. Belt hook 2. Battery holder 3. Waist belt
4. Plug 5. Jack
The battery holder has an anti-drop function. When
removing the battery holder from the belt, pull up the
battery holder while pressing the unlock button.
► Fig.10: 1. Unlock button
9 ENGLISH
4 Strap hole
4 Code lock
4 Code lock
- -