Specifications; Functional Description - Makita CV100D Betriebsanleitung

• Charge the battery cartridge with room temperature at
10°C - 40°C (50°F - 104°F).
• Let a hot battery cartridge cool down before charging it.
• Charge the battery cartridge if you do not use it for a
long period (more than six months).
(See the last part of this instruction manual for all the illustrations.)
DESIGNATION OF PARTS (Fig. 1)
1. Power button
2. Battery holder pocket (Backside)

SPECIFICATIONS

Model
Temperature adjustment steps
Material
USB power supply port
Operating time (h)
Rated voltage (V)
Battery cartridge
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Operating time may differ depending on battery type and usage condition.

FUNCTIONAL DESCRIPTION

Switch action
To turn on the vest, push and hold the power button
(about 1.5 seconds). To turn off, push and hold the power
button again.
Temperature adjustment
There are three temperature settings (high, medium, low).
Three LED lights means that the temperature is set to
"high", two LED lights "medium", and one LED light "low".
When you switch on the vest, the temperature is set to
"high". Each press of the power button cycles through the
vest's temperature setting.
ASSEMBLY
CAUTION:
• Hold the battery holder and the battery cartridge
firmly when installing or removing battery
cartridge. Failure to hold the battery holder and the
battery cartridge firmly may cause them to slip off your
hands and result in damage to the battery holder and
battery cartridge and a personal injury.
4
3. Power cable (Inside the battery
holder pocket)
CV100D
Nylon 100% (outer and lining), polyester 100% (armhole and padding)
With battery BL1013
Low APPROX. 4.5
Medium APPROX. 2.5
High APPROX. 1.5
10.8
BL1013
• For an optimum life-time, the battery cartridge have to
be fully charged, after use.
SAVE THESE INSTRUCTIONS.
–
With battery BL1450
APPROX. 21
APPROX. 11
APPROX. 6
BL1415, BL1415N,
BL1430, BL1440,
BL1450
Installing or removing battery cartridge to
the battery holder (Fig. 2)
for CV100D
To install the battery cartridge (5), hold it so that the
battery cartridge front shape fits to that of the battery
holder opening and slip it into place. Insert it all the way
until it locks in place with a little click.
Always insert the battery cartridge all the way until it locks
in place. If not, it may accidentally fall out of the battery
holder, causing injury to you or someone around you.
Do not install the battery cartridge forcibly. If the cartridge
does not slide in easily, it is not being inserted correctly.
To remove the battery cartridge, withdraw it from the
battery holder while pressing the buttons (6) on both sides
of the cartridge.
for DCV200
To install the battery cartridge (7), align the tongue on the
battery cartridge with the groove in the battery holder and
slip it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator (8) on the
upper side of the button, it is not locked completely.
Always install the battery cartridge fully until the red
indicator cannot be seen. If not, it may accidentally fall out
of the battery holder, causing injury to you or someone
around you.
4. Battery holder
DCV200
3
DC 5V, 2.1A
With battery BL1850
APPROX. 31
APPROX. 16
APPROX. 9
14.4
BL1815, BL1815N,
BL1820, BL1830,
BL1840, BL1850
18