Ventilation Requirements; Door Reversibility; Installing The Appliance - Electrolux ERN2201AOW Benutzerinformation

rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the
E.E.C. Directives.

8.3 Ventilation requirements

The airflow behind the appliance must be
sufficient.
min.
5 cm
200 cm
CAUTION!
Refer to the assembly
instructions for the
installation.

8.4 Door reversibility

The door of the appliance opens to the
right. If you want to open the door to the
left, follow these steps before you install
the appliance:
1. Loosen and remove the upper pin.
2
min.
2
200 cm
2. Remove the door.
3. Remove the spacer.
4. With a key, loosen the lower pin.
5. Tighten the lower pin on the opposite
side.
6. Install the spacer.
7. Install the door.
8. Tighten the upper pin.

8.5 Installing the appliance

CAUTION!
Make sure that the mains
cable can move freely.
1. If necessary cut the adhesive sealing
strip and then apply it to the
appliance as shown in figure.
ENGLISH 11