Set Up; Charging Mobile Phones And Tablets; Using The 12Vdc 8A Output With Cigarette Lighter Adapter - ULTIMATE SPEED UPBS 12000 A1 Bedienungs- Und Sicherheitshinweise

Step
2. First connect the
red clamp A to
the positive pole
of the vehicle
battery and then
connect the black
battery clamp B
to the negative
pole (see picture
1).
3. Starting up
the vehicle
1
As soon as the vehicle starts,
remove the jumper cable
start aid within 30 seconds and disconnect
firstly the black battery clamp and then the
red clamp from the battery poles.
Otherwise dangerous situations can arise!
Leave the vehicle engine running.
„ „
Note: The button on the LED box
the jumper cable has no effect and must not
be used. It is only used for troubleshooting
purposes during the manufacture of the
device.
LEDs
11
LED flashes red, a
short warning signal
sounds
11
LED flashes red, a
continuous warning
signal sounds
LED 11 flashes red once,
a continuous warning
signal sounds, followed
by two short warning
beeps
11
The red and green
LED 10 flash alternately.
After 1–2 seconds only
the green LED glows
B A
2. 1.
from the jump
8
13 from
Meaning/Error
The temperature is
too high, possibly
due to several jump
start attempts
Battery clamps A
and B are the wrong
way round.
It is caused by a
shortcircuit or the
battery is leaking
The connection is
correct
10
• Charging mobile phones
and tablets
Press the power switch
„ „
Connect your mobile phone or tablet's
„ „
USB power cable to the USB output (5V
/ 1A /2A
3a 3b
phone or tablet.
Note: Charging is not possible if the power
pack itself is being charged.
• Using the 12VDC 8A output
with cigarette lighter adap-
ter
Press the power switch
„ „
Connect the 12V/8A cigarette lighter ad-
„ „
apter to the 12VDC 8A output
15
your power bank and then connect this to
your device.

Set up

Solution
Disconnect the
black battery
clamp first and
then the red
clamp from the
battery poles.
Start again from
step 1
Carry on to step
3
4 .
) and then to your mobile
.
4
on
14
GB/IE/NI 11