Electrolux KIV64463 Benutzerinformation Seite 16

16 www.electrolux.com
Problem
Residual heat indicator
does not come on.
Automatic Heat Up does
not operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no sound when
you touch the panel sensor
fields.
comes on.
comes on.
and a number come on. There is an error in the
You can hear a constant
beep noise.
Possible cause
The zone is not hot be‐
cause it operated only for a
short time or the sensor is
damaged.
The zone is hot.
The highest heat setting is
set.
Power management oper‐
ates.
The cookware is too large
or you put it too near to the
controls.
The sounds are deactiva‐
ted.
Child Safety Device or
Lock operates.
There is no cookware on
the zone.
The cookware is unsuita‐
ble.
The diameter of the bottom
of the cookware is too
small for the zone.
hob.
The electrical connection is
incorrect.
Remedy
If the zone operated suffi‐
ciently long to be hot,
speak to an Authorised
Service Centre.
Let the zone become suffi‐
ciently cool.
The highest heat setting
has the same power as the
function.
Refer to "Daily use".
Put large cookware on the
rear zones if possible.
Activate the sounds. Refer
to "Daily use".
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware.
Refer to "Hints and tips".
Use cookware with correct
dimensions. Refer to
"Technical data".
Deactivate the hob and ac‐
tivate it again after 30 sec‐
onds. If comes on
again, disconnect the hob
from the electrical supply.
After 30 seconds, connect
the hob again. If the prob‐
lem continues, speak to an
Authorised Service Centre.
Disconnect the hob from
the electrical supply. Ask a
qualified electrician to
check the installation.