Replacing The Door Cylinder (Optional) - Abus PR2800 Montage- Und Bedienungsanleitung

Fig. 2
DIN right
Hinge thickness
Hinged door
Door that opens inward
Fig. 3
PR2800
78
DIN left
Unhinged doors
Door that opens outward
Fig. 4
PR2800
PR2800
IV. Fitting tools
• Phillips screwdriver
• Drilling machine for wood, metal and walls
• Metal drill: Ø 3.0 mm
(also use with wood) Ø 3.5 mm
Ø 5.0 mm
Ø 8.5 mm
Ø 10.0 mm
• Masonry drill bit: Ø 10.0 mm, length of at least 180 mm
Ø 6.0 mm
Ø 16.0 mm, for a wall lock
• Milling cutter/hole saw: Ø 53–58 mm
• Mechanic's level, metering rule
• Hexagon socket screw key SW 3, SW 4, SW 5
• Metal saw, file
• Tools for additional work are not included in this installation
V. Replacing the door cylinder (optional)
If the door cylinder does not need to be replaced, continue to read under chapter VI.
1. Remove the safety screw (1) and the sliding casing (2). (Fig. 5)
2. Mark the locking position to the lock body for locked door bars (Fig. 9)
and remove the door cylinder in the specified order according to Fig. 5.1.
3. Change the grub screw (6) and the gear-wheels clip (5) of the standard door cylinder
to the new door cylinder, according to Fig. 5.1. The grub screw (6) must protrude at the
same distance on both sides.
If the cylinder length does not change, continue to point 8.
4. Unscrew the loosened screws (1, Fig. 7), move the gear-wheel housing in the direction
of the arrow. Unscrew the cylinder protection's screws located beneath (Fig. 7).
Press the toothed gear rack a bit to the side if necessary.
Table 1
Door panel Cylinder dimensions in mm
thickness in mm
(Dimension inside/Dimension outside)
33 – 48 30/60
49 – 58 30/70
59 – 68 30/80
69 – 78 30/90
79 – 88 30/100
89 – 98 30/110
99 – 108 30/120
Use the door half-cylinder 10/30 during fitting without the possibility of closing from
the outside.
Spacer discs with a thick- Screws DIN 7984– 8.8
ness of 10 mm, Quantity in mm
– enclosed
enclosed
1
2 enclosed
3 M6 x 60
4 M6 x 60
5 M6 x 70
6 M6 x 70
GB
79