Operation; Weighing Mode - OHAUS YS Serie Bedienungsanleitung

YS Series Balances

3. OPERATION

3.1 Weighing Mode

Use this mode to measure the weight of a sample in the selected unit of measure.
1. Repeatedly press MODE until the desired unit is displayed.
2. Press TARE to set the display to zero.
3. Add material to the pan.
4. The display shows the weight of the material on the pan.
To weigh material in a container:
1. Press TARE to set the display to zero.
2. Put an empty container on the pan; then press TARE to tare the container
weight.
3. Add material to the container.
4. The display shows the net weight of the material.
3.2 Counting Mode
Use this mode to count parts of uniform weight. The balance determines the quantity
based on the average weight of a single part. All parts must be uniform in weight for
accurate measurements.
1. Repeatedly press MODE until
2. Put an empty container on the pan; then press TARE to tare the container
weight.
3. The display shows the sample size
4. To change the sample size, repeatedly press TARE/On until the desired quantity
is displayed:
Add 5
...
PC
5. Add the displayed number of parts to the container; then press TARE/On.
6. The display shows the current number of parts
Note: To exit or restart Counting at any time, press and hold TARE/On until
displayed. Return to step 2 to restart, or press MODE/Off for other weighing
functions.
PC
Add 10 Add 20
,
PC PC
CON
is displayed.
Add 5
.
PC
Add 30
,
PC
PC
Add 40
, ,
PC PC
5
.
EN-3
Add 50
,
CON
is
PC