Patton Kamado 21” Schwarz Bedienungs- Und Montageanleitung Seite 30

Parts list
1 (4x)
2 (2x)
3 (2x)
Prior to Assembly: Read the instructions carefully. Check all parts against the parts list.
Carry out assembly on a soft surface to avoid scratching the paint. Please retain this information for future reference.
For ease of assembly on ly loosely ti ghten bolts and then tighten fully when assembly is complete.
WARNING - DO NOT over tighten bolts; only tighten with moderate pressure to avoid damaging the bolts or
components of the Kamado Gril.
Assembly Instructions
IMPORTANT - Remove any packaging before use, but retain the safety instructions and store them with this product.
ASSEMBLY
STEP 1 - Attach the four pre-threaded castor wheels (2 & 3) to each of the four brackets (1) by pushing them
through the hole. Using an adjustable spanner secure each castor wheel with 1x nut (B).
STEP 2 - To assemble the cart insert the two cross pieces (4) into one of the four brackets (1) from both the top and
bottom.
STEP 3 - Continue to insert the cross pieces (4) into the other three brackets (1).
STEP 4 - Secure the brackets (1) to the cross pieces (4) by using the 8x screws (A). Make sure the cart is secure
and all of the screws are tight before placing the Kamado Grill (9) into it.
STEP 5 - To place the Kamado Grill (9) on the cart first remove all of the items that are inside of the grill to make
lifting easier.
STEP 6 - Use a minimum of two people when lifting the Kamado Grill onto the cart. Place one of your hands in the
bottom vent of the Kamado and the other under the grill. Lifting by the hinge or the side tables could result
in injury and will void the warranty if damage occurs.
STEP 7 - Place the Kamado Grill on the cart with the bottom vent facing to the front of the cart allowing the vent
to open and close without any interrution.
4 (2x)
5 (1x)
6 (1x)
7 (1x)
8 (1x)
GB, IE
9 (1x)
A (8x)
B (4x)
30