Specifications - Makita HP2070 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Lock button
1-2. Switch trigger
2-1. Speed adjusting dial
2-2. Higher
2-3. Lower
3-1. Lamp
4-1. Reversing switch
5-1. Arrow
5-2. Speed change knob

SPECIFICATIONS

Model
Speed
Capacities
No load speed (min
Blows per minute
Overall length
Net weight
Safety class
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone.
It is also suitable for drilling without impact in wood, metal,
ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
6-1. Action mode changing lever
7-1. Grip base
7-2. Side grip (auxiliary handle)
7-3. Teeth
7-4. Protrusions
8-1. Chuck key
9-1. Sleeve
9-2. Ring
10-1. Sleeve
Concrete
Steel
Wood
-1
)
ENE042-1
ENF002-2
ENG905-1
) : 99 dB(A)
pA
) : 110 dB(A)
WA
HP2070/HP2070F
High Low
20 mm -----
8 mm 16 mm
25 mm 40 mm
0 - 2,900 0 - 1,200
0 - 58,000 0 - 24,000
364 mm
2.6 kg
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: impact drilling into concrete
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
3
10-2. Hexagonal nut
10-3. Wrench 19
10-4. Retaining ring
11-1. Depth gauge
12-1. Blow-out bulb
13-1. Power-ON indicator lamp (green)
13-2. Service indicator lamp (red)
14-1. Vent holes
15-1. Vent holes
HP2071/HP2071F
High
20 mm
8 mm
25 mm
0 - 2,900
0 - 58,000
362 mm
2.6 kg
/II
2
) : 16.0 m/s
h,ID
2
2
) : 2.5 m/s
h,D
2
Low
-----
16 mm
40 mm
0 - 1,200
0 - 24,000
ENG900-1
ENG901-1