Chattanooga Group OptiFlex3 2090 Bedienungsanleitung Seite 18

SETUP
NEW PATIENT SETUP
Securing Patient
After patient is positioned and all
adjustments are made, secure the patient
to the OptiFlex 3 using the strap included
in the Softgoods Kit.
Starting/Stopping Treatment
After all parameters have been made, see
pages 7 through 11, start treatment by
pressing the Start/Stop (Emergency Stop)
button.
Stop Treatment by pressing the Start/Stop
(Emergency Stop) button.
OptiFlex® 3 Continuous Passive Motion (CPM) Therapy Unit
15
Comfort Zone ™
If the patient experiences discomfort, the
Comfort Zone button may be pressed
and the carriage will immediately reverse
direction and move toward the extension
angle. For the next five cycles, the carriage
will operate in a range 5° less than the angle
where the button was pressed. Once five
cycles are complete, the Comfort Zone
Flexion Angle will increase by 1° each cycle
until it reaches the Programmed Flexion
Angle.
Emergency Stop
Should the patient need to stop the
treatment , they may press the Start/Stop
(Emergency Stop) button once and
treatment will immediately stop.