Respekta CH 44099 GIS A Bedienungsanleitung Seite 28

5. Connect the suspension device with 8 screws type M4*10 and M4 nuts to the
angle irons (fig. 2).
6. Calculate the needed length of the angle irons. Fix the angle irons with 16 big
flathead screws type M4*10 and M4 nuts with seal. An overlapping length of at
least 100 mm is required.
7. Insert the extension tube in the 170 mm-hole and lead it outwards (fig. 3).
8. Fix the inside chimney with 4 screws type ST4*8 on the suspension device.
Push the outside chimney on the inside chimney. Use the S-hook to hold the
chimney while installing it.
9. Fix the chimney with 4 screws type ST4*8 (fig.5)..
10. You need at least two persons to lift the hood(fig. 6). Fix the hood with 16
screws type M4*10 on the angle irons.
11. Now pull the extension tube and fix it (fig. 7). Ensure that there are not any
gaps. Remove the S-hook and pull the outside chimney at its proper position
(fig.8).
12.
28