Fault Finding - Ikra GM AAS 4025 Gebrauchsanweisung

- Slacken the saw chain after completing work because
it shortens when cooling. This prevents the chain
being damaged.
- Always replace the protective cover for transport or
storage of the chainsaw.
- Store the chainsaw in a safe and dry place and out of
the reach of children.
- When transporting the tool by car, it must be posi-
tioned so that it poses no danger, and secured.

Fault finding

Caution!
Switch off the machine and pull out the mains plug before commencing fault finding.
The following table shows fault symptoms and describes how they can be rectified if your machine is not functioning
properly. If this does not help you localise and rectify the problem, contact your service workshop.
Cause
Chainsaw does not operate
Chainsaw operates irregularly
Saw chain dry
Chain/guide rail hot
Chainsaw jumps up, vibrates or
does not saw properly
GB | Operating Instructions
Oiling the chain
The saw chain must be oiled before use and after clean-
ing. Only use the correct oil.
Fault
The battery is empty
The battery is faulty
Internal loose connection
Defective on/off switch
No oil in the tank
Ventilation in the oil tank cap clogged
Oil tank flow channel clogged
No oil in the tank
Ventilation in the oil tank cap clogged
Oil tank flow channel clogged
Dull chain
Chain tension too loose
Dull chain
Chain worn out
Saw teeth pulling in the wrong
direction
12
Remedy
See „Charging the rechargeable
battery"
Have it replaced by our specialist
service department.
Take saw to a specialty workshop
Take saw to a specialty workshop
Re-fill oil
Clean oil tank cap
Unclog oil flow channel
Re-fill oil
Clean oil tank cap
Unclog oil flow channel
Re-sharpen or replace chain
Adjust chain tension
Re-sharpen or replace chain
Replace chain
Re-mount saw chain with
teeth in the correct direction