Ikra GM AAS 4025 Gebrauchsanweisung Seite 30

2) Electrical safety
a) The mains plug of the power tool
must fit into the mains socket. The
plug must not be modified in any way.
Do not use adapter plugs/connectors
in combination with tools with pro-
tective earthing. Unmodified plugs and
fitting sockets reduce the risk of electric
shock.
b) Avoid physical contact with earthed
surfaces as pipes, heaters, ovens and
refrigerators. There is an increased risk
of electric shock if your body is earthed.
c) Keep the tool out of the rain or mois-
ture in general. The penetration of wa-
ter into a power tool increases the risk of
electric shock.
d) Do not use the cord to carry or hang
up the tool or to pull the plug out of
the socket. Keep the cord away from
heat, oil and sharp edges or moving
parts of the tool. Damaged or tangled
cords increase the risk of electric shock.
e) When operating a power tool out-
doors, use exclusively extension
cords that are approved for out-
door-use. The use of an extension cord
that is suitable for outdoor use reduces
the risk of electric shock.
f) If the operation of a power tool in a
moist environment cannot be avoided
it is highly recommended to use a re-
sidual current device (RCD). The use
of an RCD reduces the risk of electric
shock.
3) Personal safety
a) Always pay attention to what you
do and apply reasonable care when
working with a power tool. Do not use
the power tool when you are tired or
under the influence of medication,
drugs or alcohol. When working with
power tools, even a short moment of in-
attentiveness may result in severe injury.
GB | Operating Instructions
b) Wear personal protection equipment
c) Avoid unintentional operation. Make
d) Remove adjustment tools or wrench-
e) Avoid unusual postures. Make sure
f) Wear suitable clothes. Do not wear
g) If dust extraction/collection devices
4) Use and handling of the power tool
a) Do not overtax the power tool. Use
5
and always wear eye protection (safe-
ty goggles). Wearing personal protec-
tion equipment as a dust mask, non-
slip safety shoes, safety helmet or ear
protectors (depending on the type and
application of the tool) reduces the risk
of injury.
sure that the power tool is switched
off before you connect it to the mains
supply and/or the battery and when-
ever you pick up or carry the tool.
When carrying the tool with your finger
on the on/off switch or connecting the
tool to the mains supply with the switch
in 'ON' position, this may result in acci-
dents.
es and the like before you switch the
power tool on. A wrench or other tool
that is inside or on a rotating part of the
tool may cause injury.
to have a safe footing and keep your
balance at all times. This will allow you
to better control the power tool in unex-
pected situations.
wide clothing or jewellery. Keep your
hair, clothes and gloves clear of all
moving parts. Loose clothing, jewellery
or long hair may get caught in moving
parts.
are provided make sure that they are
connected and used properly. The use
of a dust extraction device may reduce
risks caused by dust.
the power tool intended for your type
of work in each case. The use of the
suitable power tool within the stated