Combustion Air; Correct Operation - Austroflamm Wien Benutzerhandbuch

english
Floor load capacity
Make sure that the load capacity of the supporting
construction is sufficient to carry the weight of the
, before the heating unit is installed.
entire unit

Combustion air

Being the user of the stove you must take care of a
sufficient combustion air supply. Sealed-up windows
and doors may not allow a sufficient combustion air
supply or disturb the draught behaviour of your stove.
Please ensure the additional supply of fresh
3. CORRECT OPERATION OF YOUR STOVE
Maximum amount of fuel
Maximum amount of fuel to be added: appr. 3,3 kg
wood
. Larger amounts of fuel can lead to overheating
and thus damage the stove.
Clean burning
The wood must be dry (relative wood moisture
< 15%) and untreated. The right amount of wood
must be burned in order to ensure a clean fire that
releases only small amounts of emissions.
Making a fire
Prepare everything you need for starting the firesoft
wood chips, igniter materials (such as Austroflamm
lighter), wood. Figure 1 provides a good overview of
the quantity of the materials you will need.
Open the primary and secondary air all the way.
Move both sliders. See figure 2.
Open the stove door.
Put ignition aid on the floor of the firebox.
Lay soft wood chips onto the paper.
Lay one or two logs of wood on the wood chips.
Figure 3: Igniting the Fire
Light the ignition aid. Close the firebox door. As soon
as the chips burn well, close the primary air supply
See Figure 2.
5
combustion air if necessary. For details please
consult your specialist retailer.
Stove pipe connection
For your own safety stringent laws apply for
connecting the stove pipes to the chimney. Your
professional dealer or distributor knows these laws.
Please have your certified retailer carry out the
connection of your stove.
Figure 4: Close the Primary Air
As soon as the wood logs are burning well too, you
can regulate the heating capacity with the
secondary air slider. (slider set to the maximum
("AUF") setting produces maximum heat – see
figure 2.)
When adding wood to the fire, follow the same
procedure as when igniting the fire: Open primary
air, open secondary air, carefully open firebox
door, lay wood on the fire, close the firebox door.
Wait until the added wood catches fire and is
burning. Then close the primary air. Subsequently
regulate the fire with the secondary air supply.
Heating in between seasons
Heating the stove in between seasons, when the
outside temperatures are higher, the flue gases
may not be able to escape completely and this
may lead to disturbances in the chimney draught,
especially if the temperatures are rising suddenly.
The stove has to be charged with less wood and
the primary air has to be increased so that the
.
wood can burn down faster (with visible flames)
and thus the chimney flue can stabilize.
Wien