General Information; Target Group; Intended Use - Parker ED 4100/50 Series Betriebsanleitung

General information

These operating instructions contain basic
information on the installation, operation,
maintenance as well as the safe use of the
ED4100/50 condensate drain. The operating
instructions must be available at condensa-
tion drain at all times.
Characters and symbols used
Lists are marked by a bar.
▌
- Work steps that you have to carry out in
the specified order.
Caution!
These safety notes warn against
damage to property and help you to
avoid such damage.
Danger!
Type/source of danger
This safety information with a grey back-
ground warns against personal injury and/
or danger to life and limb; safety information
relating to dangers helps you to avoid seri-
ous or life-threatening situations for yourself
and/or third parties.
• Measure(s) to eliminate the danger.
)
Always comply with these instructions
to ensure safe and efficient operation
of the machines and devices.

Target group

This operating manual is intended for all
persons that are involved in work with and
on the condensate drain. Such persons
must be trained in handling pressure devices
and electrical equipment. Based on their
qualifications and experience, these persons
have the necessary skills to handle pressure
devices.
ED4100/50_01
Operating Instructions | EN
Scope of delivery
The condensate drain is supplied with a
corresponding wall mounting bracket. After
connecting the condensate inlet and outlet
as well as setting up the electrical connec-
tion, the ED4100/50 is ready for operation.
Product ID
The product designation for the condensate
drain is made up of the following ID code:
ED 4100 /

Intended use

The condensate drain is designed solely
for the purpose of removing/draining liquid
condensate, containing no aggressive com-
ponents, from compressed air and com-
pressed air systems.
The condensate drain must be installed only
in a weather-protected environment with
ambient temperatures above freezing. A
heating system must be installed at ambient
temperatures below freezing. Operation of
the optionally available heater is permitted
only at ambient temperatures between -25
°C and 5 °C. The condensate drain must
operate free of vibration. Any other use is
deemed improper.
Impermissible applications
The condensate drain must not be used
to drain off condensate containing aggres-
sive components. The ED4100/50 must not
be operated in a vacuum or in atmospheric
systems. Changes to the condensate drain
are not permitted.
50 -
17