Connecting To Network; Connecting With The Musiccast Controller - Yamaha NX-N500 Bedienungsanleitung

Connecting to network

• Some security software installed on your PC or the firewall settings of network devices (such as a router) may block the access of the unit to the network
devices or the Internet. In these cases, configure the security software or firewall settings appropriately.
• A connection cannot be established if the MAC address filter is enabled on the router. Check the router settings.
• Each server must be connected to the same subnet as the unit.
• To use the service via the Internet, broadband connection is strongly recommended.

Connecting with the MusicCast CONTROLLER

In order to use a mobile device installed with the dedicated
"MusicCast CONTROLLER" app, simply follow the instructions
in the MusicCast CONTROLLER screen to specify the network
settings.
When playing a high-resolution audio source via the network, we
recommend connecting with a wired router for stable playback.
• Connect the mobile device in which the "MusicCast CONTROLLER" app
has been installed to the wireless router (access point) in advance.
• If this unit will not be connected to the Internet, streaming services such
as Internet radio cannot be used. To use streaming services, connect the
unit to a Internet with a wired router or wireless router (access point).
1
Perform the setup according to the network
connection method (wired or wireless).
When connecting to the network using a cable:
Make sure that the unit is connected to the router with a
cable.
When connecting to the network wirelessly:
If a wired connection has already been established,
disconnect the network cable from the unit.
2
Set the WIRELESS switch on the rear panel to
"AUTO".
Left speaker (rear panel)
AC IN
GAIN
MIN MAX
3
Start up the MusicCast CONTROLLER app on the
mobile device, and then tap "Setup".
If you have already connected a another MusicCast
compatible device to the network, tap "Settings" and
then "Add New Device".
12
En
R CH
AUDIO OUT
WIRELESS switch
AUTO
WIRELESS
OFF
CONNECT
WIRELESS
DIRECT
SOURCE
4
Follow the procedure in the MusicCast
CONTROLLER screen to turn on the unit.
While the connection is being set up, the status indicator
on the front panel flashes in green.
Left speaker (front panel)
5
Hold down CONNECT on the remote control (or
CONNECT on the rear panel) for at least 3
seconds.
Remote control
Left speaker (rear panel)
AUTO
AC IN
GAIN
MIN MAX
Green (flashing)
CONNECT
R CH
AUDIO OUT
WIRELESS CONNECT
OFF
CONNECT
WIRELESS
DIRECT
SOURCE