Positioning The Speakers; Turning On The Main Power; Network Standby; Auto Power Standby - Yamaha NX-N500 Bedienungsanleitung

Positioning the speakers

6
• Place each speaker on a sturdy and stable surface.
• When connecting to a TV, place the speakers to the left and
right of the TV.
• The ideal stereo effect will be obtained by slightly angling
the front panels in toward the listener.
Left speaker
• When used near a CRT TV, separate the speakers from the TV if color
distortions or noise occur.

Turning on the main power

After all cables have been connected, press the z (power)
switch on the rear panel to turn on the main power of the
unit.
• If no network connection has been set up when the main power is
turned on, the indicator flashing in pink, and the unit automatically
searches for an iOS device (iPhone or iPod touch). For details on network
connections with iOS devices, see "Sharing the iOS device setting" (p.15).
Left speaker (rear panel)
R CH
AUDIO OUT
AUTO
WIRELESS
OFF
CONNECT
WIRELESS
DIRECT
SOURCE
GAIN
MIN MAX
z (power) switch
After the main power for the unit has been turned on, the
unit can be turned on or switched to standby by using z
(power) on the remote control.
To turn on/off the unit with the MusicCast CONTROLLER, the
network function must be enabled, even when the unit is in
standby mode (network standby).
For details on network standby, refer to the following section.
Right speaker
Left speaker (front panel)
Pink

■ Network standby

The network function can be enabled, even when the unit is
in standby mode (network standby).
If network standby is turned off, the unit can enter standby
mode using the minimum standby power (eco standby).
Use the web browser on the PC to change the network
standby setting (p.29).
• As a default, network standby is set to "Auto". If the unit has been
disconnected from the network for 8 hours while it is in network standby
mode, it switches to eco standby mode.

■ Auto power standby

If no operation is performed or nothing is played back, the
unit will automatically enter standby mode (auto power
standby).
MusicCast CONTROLLER can be used to change the auto
power standby setting.
Standby time with no operation
All inputs:
Standby time with no playback
Network, Bluetooth and USB:
Default setting : On
8 hours
20 minutes
11
En