Connecting To Your Amplifier; Standard Connections - Yamaha NS-F500 Bedienungsanleitung

Notes
• Be sure to have another person support it.
• Pay extra attention to avoid scratching the speaker's surface.
• Be careful not to apply force to the side of the speaker,
otherwise the speaker may fall causing damage to the
speaker or personal injury.
• To avoid accidents resulting from tripping over loose
speaker cables, affix them to the floor.
• Placing this unit too close to a CRT TV set might impair
picture color or create a buzzing noise. In this case, move the
speakers away from the TV. This is not an issue with LCD
and plasma TVs.
• The legs feature an adjustment function that enables you to
fine-tune the speaker height. If the speaker rattles on the
floor, adjust the length of the legs by turning them. Do not
loosen the legs too much. Otherwise, they may come off.
Loosen
(higher)
Tighten
(lower)
Leg
4
En
■
Attaching the spikes
At the time of shipment, legs are attached to the speaker. When
you use the supplied spikes, please remove the legs first.
If you are setting up the speaker on a thick carpet, you can
replace the legs with the spikes to increase stability and
improve sound quality. Remove the legs by turning them,
then follow the steps below:
Notes
• Be sure to have another person support it.
• The tips of the spikes may scratch or damage the flooring.
Please be careful when positioning the speakers.
• The tips of the spikes are sharp. When you adjust the protruding
length of the spikes, be careful not to injure your fingers.
1.
Lay the speaker on the floor.
Use a blanket or cushion to avoid scratches.
2.
Screw each spike into a spike nut so that the nut will stay
near the tip of the spike.
Spike
Spike nut
3.
Remove the legs and screw the spikes into the holes on
the bottom of the speaker.
4.
Place the speaker in the desired location in an upright
position. If necessary, adjust the length of the spike to
match the depth of the carpet by repeating the above-
mentioned steps.
5.
When the length adjustment is complete, firmly tighten
the spike nut to the base on the bottom of the speaker.
CONNECTING TO YOUR
AMPLIFIER
Before making connections, make sure that the amplifier is
switched off.

Standard connections

Note
Do not insert the insulation into the hole.
If the connections are faulty, you will hear no sound
from the speaker.
Loosen
Black (–)
Insulation coating
NS-F500
Amplifier
or Receiver
Tighten
Red (+)
Bare wire
NS-F500
Speakers
output
terminals