Privileg SY-6010BS-P1-C83-L41-600 Gebrauchsanleitung Seite 27

Determining the drill holes
Calculating drill holes
(8) Minimum distance between
stovetop and lower edge of
exhaust hood
(9) Distance between lower
edge of exhaust hood and
upper fixing lugs
(10) Distance between the fixing
screws
1. Remove the cover (6) and carefully put
it aside.
2. In order to place the appliance exact-
ly over the centre of the stovetop, first
use the pencil to draw a vertical guiding
line on the wall. Ideally, use a level or a
plumb bob from the ceiling of the room
to the middle of the stovetop.
196377_GB_20180522.indd GB-9 196377_GB_20180522.indd GB-9
(10)
(9)
3 2 1 0 1 0
(8)
Di-
men-
sions
in cm
70 - 80
7.5
50
(6)
Assembly
2x
3. Draw the two drill holes for the keyhole
openings on the wall according to the
diagram in the left column. Pay attention
to the height information (8) and (9), the
distance between the fixing screws (10)
and the horizontal alignment.
4. Drill holes at the marked points using
a diameter that can accommodate the
dowels.
5. Place the dowels into the holes.
6. Screw the round-head screw into the
dowels until they are firmly seated.
There must be enough space to hang
the exhaust hood.
7. Hang the exhaust hood.
8. Check the horizontal position of the ex-
haust hood.
9. Mark the mounting holes below the key-
hole openings with a pencil.
10. Remove the exhaust hood again.
11. Drill holes at the marked points using
a diameter that can accommodate the
dowels.
12. Place the dowels into the holes.
13. Hang the exhaust hood again.
14. Secure it by screwing in the lower fixing
screws.
15. If necessary, tighten the upper screws.
Wall mounting is now complete.
Page GB-9
22.05.2018 08:41:35 22.05.2018 08:41:35