Privileg SY-6010BS-P1-C83-L41-600 Gebrauchsanleitung Seite 26

Page GB-8
1. Remove the cover (6) and carefully put it
aside.
2. Hold the exhaust hood under the wall unit.
How close you can hang the exhaust hood
to the wall depends on the depth of the
wall unit. The ventilation grilles (7) must re-
main clear and must not be covered.
3. Mark the drill holes using a pencil.
(2)
(3)
(3)
(4)
4. Screw on the exhaust hood as shown in
the diagram above.
This is the final step for the substructure.
Continue with section „Final steps" on page
GB-10.
196377_GB_20180522.indd GB-8 196377_GB_20180522.indd GB-8
Assembly
(6)
(7)
Wall mounting
WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
Before drilling the holes, ensure that
■
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
The distance between the cooking
■
surfaces and the lower edge of the
hood must be at least 70 cm for gas
and electric stoves, 80 cm for coal
and oil-fi red stoves.
For gas stovetops, you must read the
■
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
The ventilation grilles must remain
■
clear.
The screws and dowels required to
mount the appliance on a wall are not
included in the package contents as
their type and dimensions will vary depend-
ing on the characteristics of the wall.
Please have a specialist advise you as to
which ones you need.
For wall mounting you will need:
– 4 round-head screws (5) with washers,
maximum ø 6 mm,
– 4 suitable dowels,
– drill with stone bit, correctly sized for the
screws(5),
– screwdriver,
– measuring tape/ruler,
– level,
– pencil,
– stable stepladder,
– a second person to help,
– work gloves.
22.05.2018 08:41:33 22.05.2018 08:41:33