MARIMEX ProStar Profi 4 Bedienungsanleitung Seite 35

7) Connecting hoses
8) 2x hose clip
9) Filter container clip incl. screw and mother
10) Ratchet rod with pre–installed filler neck
11) 6x wreath blade
12) 2x set of screws, nuts and washers to attach the pump to the base
13) Base of filtration equipment
14) Pump
15) Drain valve – installed from the inside of the filter container
16) Sealing the container
17) Reduction for hose connection 38 mm
18) Transparent lid mat – Pre–installed on the pump
19) Transparent cover of the pump suction tank
20) 2x hose (only one is used)
21) Pump coarse prefilter sieve
22) Transparent lid gasket
23) 2x O-ring
Specifications
Flow
Tension
Power consumption (W)
Cover
Water temperature max.
Sand refill max.
Grain of filter sand
Weight without filling
Installation
Filtration device location
First, select the appropriate location for filtering. It should have a solid horizontal
substrate, be well accessible, protected from rain, sunlight and before flooding
with water. Avoid installing in wells, shafts, etc., as there is a high risk of flooding
the electric pump with water. Select a place where at least 10 cm of air for engine
cooling will be located behind the pump motor. Also, there must be sufficient space
for filtering and maintenance over filtration and around it. There must be a sin-
gle–phase electric socket complying with the relevant ČSN standard. If you use the
extension cable, it must be H07RN-F type with a cross–sectional area of at least
1 mm . It is recommended to use a suitable plate size under the filter unit (concre-
2
te, stoneware, etc.) and we recommend inserting a rubber pad for vibration and
noise damping under the pump. For safety reasons, install the filter so that the
smallest distance from the edge of the pool is 2 m. Suction and return pipes / hose
ProStar Profi 4 ProStar Profi 6
4,5 m /h
3
250 W
20 kg
9,9 kg
ProStar Profi 8
8,5 m /h
3
230 V/ 50Hz
450 W
IPX 4
35 °C
35 kg
0,6–1,2 mm
11,6 kg
EN
9,5 m /h
3
550 W
75 kg
17,1 kg
35