Storing And Deleting Fm Radio Channels; Fm Radio Channels Storage; Fmw Mode Selection; Deleting Fmw Memory Channels - Midland CT 510 Bedienungsanleitung

Storing and deleting FM radio channels

FM radio channels storage

In FMW mode, press F/ and U/V; the channel number to store blinks at
the left of the frequency on the LCD.
Select the desired FM radio channel with the keypad or by rotating the
POWER/DIAL knob. Push ENT to confirm.

FMW mode selection

In FMW radio mode push VFO to skip from FMW memory mode and FMW
frequency mode. (This is possible only if some FMW radio channels have
been stored).
R E S E T

Deleting FMW memory channels

Y E S ?
In FMW memory mode, turn off the radio. Switch it on again and push
U/V at the same time. The message "DEL ?" will appear on the display and
the channel number blinks at the left of the frequency.
D E L ?
Select the channel to delete with the keypad or by rotating the POWER/
DIAL knob. Push ENT to confirm.
Repeat the same procedure to delete other channels (25 maximum).
D E L ?
12
56 | Instruction Guide Midland CT510

Technical specifications

General
Frequency range VHF: 144-146MHz / UHF: 430- 440MHz
FMW: 88 – 108 MHz (RX only)
Operating temperature -20° +55°C
Voltage 3.7V 1300mAh
Memory 128 channels
Working mode simplex
Dimensions 95 (H) x 52(L) x 31(D)
Weight 139gr (with battery and antenna)
Antenna impedance 50Ω
Duty cycle 5/5/90
Transmitter
Output power high ~ 2 W / low ~ 1 W
Max deviation wide band < 5 KHz, narrow < 2,5 KHz
Modultation distortion ≤ 5%
Current drain ≤1.5 A
Receiver
Sensitivity -122 dBM @ 12 dB SINAD
Audio distortion ≤ 5%
Audio power ≥0.5 W
Specifications are subject to change without notice.
WARNING: Direct plug-in ac/dc power supply must be used for discon-
necting the transceiver from the mains; the desktop charger must be po-
sitioned close to the unit and easily accessible.
Instruction Guide Midland CT510 | 57