Factory Settings - Balluff BAW M12MI-BLC35C-S04G Betriebsanleitung

BAW M12MI-BLC35C-S04G and BAW M12MH-BLC70G-S04G
Inductive Linear Position Sensor
6
IO-Link interface (continued)
Returning measuring range settings to factory
default
1. Activate the measuring range settings.
2. Return all measuring range settings to the factory settings
1) See chapter Factory settings on page 17
6.13

Factory settings

The following settings exist at the time of delivery and after
resetting to factory settings:
Binary data channel factory settings
Parameters
Setpoint SP1
Setpoint SP2
Switchpoint mode
Switchpoint logic
Switchpoint hysteresis
Tab. 6-12: Factory settings (binary data channel)
Measuring range factory settings
Parameters Index
Hex. Dec.
Slmin 00C8 200
Slmax 00C8 200
Inversion 00C5 197
Tab. 6-13: Factory settings (measuring range)
Reset to factory settings
All sensor parameters can be reset together.
To reset the settings separately, see Returning all switching
channel settings to factory default on page 16 or
Returning measuring range settings to factory default on
page 17.
► Return all settings (BDC and measuring range) to factory
default.
www.balluff.com
BDC1...3 Comment
Hex. Dec.
0x0000 0 Switching threshold value
0x0000 0 Functionally not supported
0x00 0 Inactive
0x00 0 Switching state NO (normally open)
0x0064 100 Default value corresponds to a digital output value of 100.
Subindex Data
format
Hex. Dec.
01 1 UINT16
02 2 UINT16
00 0 UCHAR8
Index Subindex
Hex. Dec. Hex. Dec.
003A 58 00 0
. 0002 2 00 0
1)
Default value Comment
Hex. Dec.
00C8 200 Starting point of curve
0DAC 3500 End point of curve
00 0 Non-inverted curve
Index Subindex
Hex. Dec. Hex. Dec.
0002 2 00 0
Access Value
Read/Write 0xC0
Write only 0x4E
Access Value
Write only 0x82
english 17