Factory Settings - Balluff BOS 18E-PI-RD30-S4 Bedienungsanleitung

Photoelectric Sensors
Red light diffuse reflective energetic BOS 18E-PI-RD30-S4 with IO-Link
Service data
Events
Event Meaning
Code
0x4210 Over tempe- appears/disappears
rature
0x5111 Low voltage appears/disappears
0x6350 Parameter
changed
0x8CA1 Timeout
Dynamic
Teach
0xFF91 DS Upload
Request
0x5010 Errorfunction appears/disappears

Factory settings

At delivery and after System command "Restore factory
settings" the sensor is factory-set:
Parameters of Binary Data Channel
The BDC is operated in Single Point Mode with Switch-
point logic N.O.
All Setpoint values are reset to its factory values.
BDC1
Setpoint MAX_SP*
SP1
Setpoint
SP2
Switch- Single Point
point mode Mode
Switch- N.O.
point logic
*MAX_SP corresponds
to: Switching distance
≈ 500 mm with 90%
gray card
www.balluff.com
Mode Type
Warning
Warning
single shot Notifica-
tion
single shot Notifica-
tion
single shot Notifica-
tion
Error
Instance Device Status
Application Out-of-Specification
Application Out-of-Specification
Application
Application
Application
Application
Parameters of Teach Channel
Index (dec) Parameter
0x003B (59) Teach-In
Status
Other Parameters
Index (dec) Parameter
0x000C Device
(12) Access
Locks
0x0018 Application
(24) Specific Tag
Remark
T ≈ 60 °C (U =24V)
A B
U < 18V
B
After a failed plausibility
check for SP1 and SP2
the corresponding BDC
is reset to its factory
settings.
Dynamic Teach-In
> 10 min active
After System command
„ParamDownloadStore"
Emitter defect
Factory Remark
setting
0x00 Teach State =
IDLE
Factory Remark
setting
0x0000 Data Storage
unlocked
„Sensors
World-
wide"
english 6