auna 10032295 Anleitung Seite 28

EN
28
CD programming
Up to 20 tracks can be programmed for disc play in any order. Before use,
be sure to press the Info/Stop
1. Set in CD mode & stop the CD playback.
2. Press the +10/MEM/Pre button (12) and " MEM " will appear on LCD
display.
3. Select a desired track by pressing Skip up
4. Press the +10/MEM/Pre button (12) to store the track into memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if
necessary.
6. When all the desired tracks have been programmed, press Play/Pause
/Scan button (9) to play the disc in assigned order.
7. Press Info/Stop
to clear all stored memory.
Note: The programming mode will automatically stop if no button is
being pressed in a period of about 10 seconds after pressing the +10/
MEM/Pre button (12).
MP3 track format requirement
• Bit rate : 32 kbps~320kbps
• Sampling rate : 32khz, 44.1khz and 48 kHz decodable
The performance of playing MP3 Disc is various from the quality of
recording disc and the method of recording. Furthermore, the searching
lead-time for MP3-CD is longer than normal CD due to difference format.
button (11).
button (11) to stop playback, press Stop button again
/down button (10).