Checking The Supplied Accessories; Installing Batteries; Using The Cd-Rom Manuals - Sony VPL-SW535 Kurzreferenz

Checking the Supplied Accessories

RM-PJ7 Remote Commander (1)
Lithium battery (CR2025) (1)
The battery is already installed. Before
using the remote commander, remove the
insulation film.
AC power cord (1)
Mini D-sub 15 pin cable (1.8 m) (1) (1-838-
938-11/Sony)
Projector Wall Mount (1)
Quick Reference Manual (this manual) (1)
Operating Instructions (CD-ROM) (1)
Installation manual for Projector Wall
Mount (1)

Using the CD-ROM Manuals

Insert the supplied CD-ROM into the
CD-ROM drive of your computer, and the
CD-ROM will start automatically in a few
moments. Select the Operating Instructions
you want to read. If the CD-ROM does not
start automatically, open the "index.htm"
file on the CD-ROM.
You must have Adobe Acrobat Reader 5.0
or higher installed in your computer to read
the Operating Instructions stored on the
CD-ROM.

Installing Batteries

1
Pull out the lithium battery
compartment.
Pull out the battery compartment with a
stick as shown in the illustration.
2
Insert a lithium battery.
3
Close the lithium battery
compartment.
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent
type recommended by the manufacturer.
When you dispose of the battery, you must
obey the law in the relative area or country.
Installing batteries
One lithium battery (CR2025) is supplied
for the RM-PJ7 Remote Commander. To
avoid risk of explosion, use a lithium battery
(CR2025).
Checking the Supplied Accessories
With the 3 (plus)
side facing up.
9
GB