Maintenance And Modifications - Klarstein 10032035 Bedienungsanleitung

EN
22

MAINTENANCE AND MODIFICATIONS

Defrosting
Your humidor is designed with "Auto-cycle" defrost system. During "Off-cycle" the
refrigerated surfaces of the humidor defrost automatically. Defrost water from the
humidor storage compartment drains automatically and part of it goes into a drainage
container, which is located at the back of the humidor next to the compressor. The heat
is transferred from the compressor and evaporates any condensation that has collected
in the pan. Part of the remaining water is collected within the humidor for humidity
purposes. This system enables the creation of the correct humidity level inside your
humidor required by the natural cork to maintain a long lasting seal.
Notes: The water collected by condensation, is therefore recycled. Under extremely
dry environmental conditions, you may have to add some water into the water
container provided with your humidor.
Adjusting the shelves
1 Shelf taking: According to below instruction drawing to pull out the shelf to support
bracket , press two sides of sliding roller buckles and pull out the shelf following the
arrow mark (1).
2 Shelf installation: According to below instruction drawing to push in the shelf
alignment with two sides of sliding roller following the arrow mark (2).