Herunterladen Diese Seite drucken

Maintenance & Service - Klarstein 10015798 Handbuch

Led luftbefeuchter

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

1. Glass Cover
2. Water Guard Stand
3. Mist Maker & LED Lamp
4. Glass Bowl
5. Wooden Stand
6. Transformer
1. Be care of the water lever sensor switch, don't hold it to take up the unit or scratch or bump with
hard thing, to avoid damaging the water lever sensor switch.
2. Don't move mist maker & lamp unit or pull cable while it's working.
3. Don't put your hand above the ceramic disc of the mist maker when it is working, otherwise the
ultrasonic vibration shall hurt you, but it is not electric shock.
4. Place the transformer at breezy place and it shall be far away moisture place.
1. Be sure to pour clean water and replace water in the glass bowl timely.
2. Clean the ceramic disc and the surface of the mist maker with soft cloth or cotton sticker in clean
water. Prohibited to touch or scratch the ceramic disc or the water lever sensor switch. Don't use
washing powder to clean any part of the mist maker.
3. If the unit can not generate mist after running some time, please check and confirm there has
enough water in the bowl. Meanwhile, if the LED lamp also off, pleases checks whether it has been electrified.
4. If the unit can not generate mist, but only water spray, the unit is good, the water in the container
is dirty, just replace the water in the container, it shall start to normal work again.
5. After running some time (approx 2000 hours), the mist shall be reduced, then it need to install a
new ceramic disc. Please purchase a new ceramic disc & tool from your local distributor, and refer
to the following drawing No. 2 and description to install the new ceramic disc.
a.
Unplug the unit and remove from water container.
b.
Insert the Tool into the winding ring and unscrew along counter clockwise.
c.
Remove the winding ring and old ceramic disc.
IMPORTANT, note the front and back of the ceramic disc. Be sure to reinstall with the
correct side (no black color ring side) facing up.
d.
The inside area of the unit cavity must be completely dry before the parts are
installed.
CHAL-TEC Vertriebs- + Handels GmbH; Wallstraße 16; 10179 Berlin, Germany
NOTICE & CAUTION
MAINTENANCE & SERVICE
1
2
3
4
5
6
7

Werbung

loading

Diese Anleitung auch für:

10015799