Use And Operation; Operating Noises - Klarstein 10032035 Bedienungsanleitung

USE AND OPERATION

Plug in and switch on the cellar by pressing on the power button for a few seconds.
When you use the humidor for the first time (or restart the humidor after having it shut
off for a long time), there will be a few degrees variance between the temperature you
have selected and the one indicated on the LED readout. This is normal and it is due to
the length of the activation time. Once the humidor is running for a few hours everything
will stabilize.
IMPORTANT: If the unit is unplugged, power is lost, or turned off, wait 3 to 5 minutes
before restarting the unit. The humidor will not start if you attempt to restart before this
time delay.

Operating Noises

To reach the desired temperature settings, humidors, like all humidors operating with
compressors and fans, may produce the following types of noises. These noises are
normal and may occur as follows:
• Gurgling sound - caused by the refrigerant flowing through the appliance's coils.
• Cracking/popping sounds - resulting from the contraction and expansion of the
refrigerant gas to produce cold.
• Fan operating sound - to circulate the air within the humidor.
Loading your Cigar Humidor
When put cigar inside cabinet, please keep space at back and top, and don't let cigar
touch back and top panel. Cigar storage temperature should be set 16-20°C, when
Cigar humidor is running:
• It's suitable to put bulk cigar or preparation of smoking cigar near upper outlet
because the humidity is lower.
• It's suitable to store long-term of boxed cigar at lower section inside cigar humidor.
• The design purpose for cigar humidor is for large amounts of storing cigars at safety
situation.
• Put cigar box on the cigar drawer evenly, please don't let cigar box to touch inner
shell or bottom, and don't stack cigar box at bottom or top.
EN
19