Installation - Klarstein 10032035 Bedienungsanleitung

EN
16

INSTALLATION

Before first Use
Allow 24 hours before switching on the humidor. During this time we recommend that
you leave the door open to clear any residual odors.
IMPORTANT: All models without front venting (air opening) are strictly for free
standing only.
Location
The location you have selected for your humidor should:
• be unencumbered and well ventilated;
• be well away from any heat source and direct sunlight;
• not be too damp (laundry, pantry, bathroom etc.);
• have a flat floor;
• have a standard and reliable electricity supply
• have a surge protector fitted to the electrical outlet;
• Away from the microwave oven. Certain microwave ovens do not have wave
interference shield. When placed within 1 meter vicinity of the humidor, they may
affect the operation of the humidor.
Placing in cold or hot temperature conditions may cause cellar's temperatures
fluctuating, and it will not reach the ideal one.
Installation
• Unpack and remove all of the protection and adhesive strips from the packaging around
and inside the humidor.
• The humidor must be positioned such that the plug is accessible. Release the power
cord. Move your humidor to its final location. The humidor should be installed in a
suitable place where the compressor will not be subject to physical contact.
• The unit must be leveled BEFORE loading your cigars. Your humidor is equipped
with 4 adjustable feet to facilitate easy leveling. The cooler recommends that you
tighten the back feet to the maximum and adjust the front feet to level the humidor.