Axis Q1604-E Installationshandbuch Seite 17

Note
• See also the wall mount's Installation Guide supplied in the package and available on
www.axis.com
• For technical specifications about the connectors, see the camera's User Manual available
on www.axis.com
1. Prepare the wall for installation of the wall mount. Use the wall bracket as a template
and mark the holes before drilling the holes.
2. Route the network cable and, if required, the power cable through the wall bracket.
Leave approximately 30 cm (11.8 in) of cable for connecting the camera.
3. If connecting an auxiliary device, for example an I/O, audio, or external power device, to
the camera, repeat the step above as applicable to the specific device.
4. Fasten the wall bracket to the wall by tightening the screws.
Route the Network Cable Through the Cable Hole
NO TICE TICE
NO NO TICE
Using any other than the provided cable gland may cause water to seep in and damage
the product. Cables must have a diameter of 4.0–5.5 mm.
Note
Check against the hardware overview image (see page 8) while following the steps below.
1
Cable gland
2
Gasket
3
Plug (discard)
4
Cap
1. Loosen the cable cover screws; detach the cable cover from the bottom cover.
2. Remove the cap, the plug and the gasket from the cable gland.
AXIS Q1604-E Network Camera
17