Inhaltsverzeichnis
Werbung
RS232 Fujitsu DEFAULT SETTINGS
9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking,
delay disabled, rx timeout 2 sec., ack/nack disabled, FIFO
enabled, serial trigger lock disabled.
DATA FORMAT
code length not transmitted, no header, terminator = CR,
character replacement disabled.
RS232 ICL DEFAULT SETTINGS
9600 baud, parity even, 8 data bits, 1 stop bit, handshaking
RTS always on, delay disabled, rx timeout 9.9 sec., ack/nack
disabled, FIFO enabled, serial trigger lock disabled.
DATA FORMAT
code length not transmitted, no header, terminator = CR,
character replacement disabled.
WEDGE DEFAULT SETTINGS
USA keyboard, caps lock off, caps lock auto-recognition
enabled, num lock unchanged, inter-character and inter-
code delays disabled.
DATA FORMAT
code length not transmitted, no header, terminator =
ENTER, character replacement disable.
PEN EMULATION DEFAULT SETTINGS
interpret mode, conversion to code 39 disabled, output level
normal, idle level normal, minimum output pulse 600 µs,
overflow medium, inter-block delay disabled.
POWER SAVE
scan rate 270scans/s, standby disabled, sleep state/USB
suspend disabled.
READING PARAMETERS
hardware trigger, trigger active level, no trigger timeout,
Flash On = 1 sec, Flash Off = .6 sec, one read per cycle,
safety time .5 sec, beeper intensity high, tone 2, beeper type
monotone, beeper length short, good read spot duration
medium, automatic operation aiming light enabled.
DECODING PARAMETERS
ink spread enabled, overflow control enabled, interdigit
control enabled, Puzzle Solver™ disabled, decoding safety
= one read.
: code identifier enabled, no field adjustment,
: code identifier enabled, no field adjustment,
: code identifier disabled, no field adjustment,
Werbung
Inhaltsverzeichnis
