Delivery - Unpacking; Generalities - Safety; Important Notice For Power Cables - ADB TANGO Bedienungsanleitung

TANGO

Delivery - Unpacking

Upon delivery of your equipment, open the packaging carefully and examine the material.
If you observe any damage, contact the shipping company immediately, and have your complaint
duly recorded. You may rest assured that your equipment left the factory in perfect condition.
Check whether what you have received is in conformity with the delivery notice, and whether
the notice is in conformity with your order.
In the event of any error, contact your shipper immediately to clarify the situation and receive full
satisfaction.
If you find nothing wrong, replace the material in the packing and store it in a warm place, away
from dust and humidity, while awaiting final installation.
Never leave the material on the worksite under any circumstance.

Generalities - Safety

The equipment is built in accordance with European safety standards and requires imperatively
a safety earth connection in compliance with local regulations.
To prevent any risk of electric shock, do not remove any cover or part of the enclosure.
Access to internal parts is not required for normal operation.
Refer servicing to skilled and trained service personnel exclusively.
Disconnect from the power supply prior to opening for inspection or service.
WARNING ! LETHAL VOLTAGES ARE PRESENT INSIDE
Connection to an inappropriate power source may irreversibly damage the equipment, it is the
user's responsibility to use the equipment for its intended purpose and to check the equipment
connected to it.
To obtain full benefits of the safety measures, the equipment shall be installed and serviced by
skilled and trained personnel exclusively.
Don't make any modification to the equipment.
ADB shall not accept any liability for material damages or injuries which may result from
unauthorised modifications.

Important Notice for Power Cables

Power supply cables and connectors are an important part of your equipment and contribute to
its safety.
• always use an isolator or main circuit-breaker, or main fuses to interrupt the link; never pull
on the cable.
• do not damage the cable nor the connectors in any way, check them at each installation or
at regular intervals in a permanent installation.
• do not tie together power supply cables and signal cables.
Page 4
Revision : 004
Lighting Technologies