Recording A Memory; Assigning Crossfade Times To Memories - ADB TANGO Bedienungsanleitung

I ∆000 %
000 I 000
TIME
min 00 05 sec
Lighting Technologies

Recording a Memory

TANGO can store up to 200 memories in total.
Modification includes storing, deleting, modifying and inserting.
Note that memory 000 is a blackout state, i.e. no output from the desk, and
cannot be modified or over written.
«RECORD» will record the current output of the desk into the memory number
shown in the RECORD MEMORY window on the display. This number may be
set to any whole number between 001 and 999 using the RECORD NEXT and
LAST buttons to the right of the display.
If the number displayed has already been recorded then the RECORD MEMORY
window will NOT flash.
The output of the desk may be created using a combination of the manual
Preset faders, the Effect section and any existing memory. When the «RECORD»
button is pressed the output is recorded into the memory number in the RECORD
MEMORY window. If that memory number was previously recorded (the number
was not flashing) then confirmation is requested before the old memory is over
written. As the memory is stored the RECORD MEMORY window changes to
show the next memory number.
When you record a memory for the first time, the time given by the MANUAL
TIMER fader is taken into account and stored in the memory. If that memory
number has been previously recorded, the previous time of the memory is kept.
By pressing RECORD NEXT and RECORD LAST together, the memory displayed
in the PRESET window is copied into the RECORD MEMORY window.
Replaying memories is covered in the Replaying a memory section of this manual.
Should it be necessary to change the contents of any memory then refer to the
modifying a memory section of this manual.

Assigning crossfade Times to Memories

To assign a time to a memory, you have two possibilities.
• Either you use the MANUAL TIMER fader, if the memory has not been
recorded yet, as described in the previous section.
007
• or you want to modify the time after having recorded the memory, in which
case you follow the following procedure :
Pressing the «TIME» button will allow a cross fade time to be assigned to the
memory number currently shown in the PRESET window. Using the PRESET
NEXT and LAST buttons will change the minutes figure. Using the RECORD
NEXT and LAST buttons changes the seconds.
To record the time, press «TIME» again.
TANGO
Page 15
Revision : 004