Troubleshooting - Electrolux EDC2086GDW Benutzerinformation

34 www.electrolux.com

12. TROUBLESHOOTING

Problem
You cannot activate the appliance.
The programme does not start.
The appliance door does not close.
The appliance stops during operation.
The display shows a long programme du-
ration.
The display shows a short programme du-
ration.
The display shows Err.
The display shows (e.g. E51).
1) After maximum 5 hours, the programme ends automatically
If the drying results are not
satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.
• There was too much laundry in the
appliance.
1)
Possible solution
Make sure that the mains plug is connec-
ted to the mains socket.
Check fuse in fuse box (domestic installa-
tion).
Press Start/Pause.
Make sure that the appliance door is
closed.
Make sure that the installation of the filter
is correct.
Make sure that the laundry does not catch
between the appliance door and the rub-
ber seal.
Make sure that the water container is emp-
ty. Press Start/Pause to start the pro-
gramme again.
Make sure that the weight of the laundry is
applicable to the duration of the pro-
gramme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in
the washing machine again.
Make sure that the room temperature is
not too warm.
Set the Time Drying or the Extra Dry pro-
gramme.
If you want to set a new programme, de-
activate and activate the appliance.
Make sure that the options are applicable
to the programme.
Deactivate and activate the appliance.
Start a new programme. If the problem oc-
curs again, contact the Service.
• The drum is dirty.
• Incorrect setting of the conductivity
sensor.
• The airflow slots are clogged.