Stand-By Function; At The End Of The Programme; Hints And Tips; Preparing The Laundry - Electrolux EDC2086GDW Benutzerinformation

30 www.electrolux.com
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and
options for the type of load.
The display shows the programme
duration.
4. Press the Start/Pause touchpad.
The programme starts.
9.2 Starting the programme with
delay start
1. Set the correct programme and
options for the type of load.
2. Press the delay start button again and
again until the display shows the delay
time you want to set.
3. Press the Start/Pause touchpad.
The display shows the countdown of the
delay start.
When the countdown is completed, the
programme starts.
9.3 Change a programme
1. Press the on/off button to deactivate
appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.

9.4 At the end of the programme

When the programme is completed:

10. HINTS AND TIPS

10.1 Preparing the laundry

• Close the zippers.
• Close the fasteners of the duvet
covers.
CAUTION!
Make sure that when you
close the door, the
laundry does not catch
between the appliance
door and the rubber seal.
You can delay the start of
a programme from a
minimum of 30 minutes
to a maximum of 20
hours.
• An intermittent acoustic signal
operates.
• The indicator
• The indicator
• The Start/Pause indicator is on.
The appliance continues to operate with
the crease guard phase for approximately
other 30 minutes.
The crease guard phase removes creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is
almost completed or completed.
When the crease guard phase is
completed:
• The indicator
flash.
• The indicator
• Start/Pause indicator goes off.
1. Press the on/off button to deactivate
the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Always clean the filter and
empty the water container
when a programme is
completed.

9.5 Stand-by function

To decrease the energy consumption, this
function automatically deactivates the
appliance:
• After 5 minutes if you do not start the
programme.
• After 5 minutes from the end of the
programme.
• Do not keep ties or ribbons loose (e.g.
apron ribbons). Tie them before you
start a programme.
• Remove all items from the pockets.
• If an item has the internal layer made of
cotton, turn it inside out. Make sure
that the cotton layer is always external
flashes.
comes on.
is on but does not
goes off.