Troubleshooting; Error Codes - Electrolux TWSL4E303 Benutzerinformation

22 www.electrolux.com
Use a moist cloth to clean. Dry the
cleaned surfaces with a soft cloth.
CAUTION!
Do not use furniture cleaning
agents or cleaning agents
which can cause corrosion.

11. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.

11.1 Error Codes

The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists,
contact the Authorised Service Centre.
WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an
alarm code and the Start/Pause button may flash continuously:
Possible
cause
E5A
E97
EH0
If the display shows other alarm codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the Tumble dryer check the table below for possible
solutions.
Possible cause
Appliance Motor overloaded.
Too much laundry or entrap in
the drum.
Internal fail. No communication
between electronic elements of
the appliance.
The mains supply is unstable.
10.6 Cleaning the airflow slots
Use a vacuum cleaner to remove fluff
from the airflow slots.
Remedy
The programme was not comple‐
ted. Remove the laundry from
the drum, set the programme
and restart the cycle.
The programme was not finished
properly or the appliance stoped
too early. Switch the appliance
off and on again.
If the alarm code appears again,
contact the Authorised Service
Centre.
When the appliance is showing
EH0, please wait until main sup‐
ply is stable than press start. If
the appliance pause the cycle
without any indication then press
the cycle start. If the warning will
occur check the power cord /
socket integrity or main supply.