Controller's Electric Connection; Connection Of Mains; Connection Of Sensors, Room Units And Bus - Inocal PROMATIC CMP25-2 Bedienungsanleitung

CONTROLLER'S ELECTRIC CONNECTION

Pictures, diagrams and text in this manual are intended solely as an example and the
manufacturer does not accept any responsibility for them. If you use content of this
manual as a base for your project, then you carry also full responsibility for it.
Responsibility of publisher for unprofessional, wrong and false information and con-
secutive damage are explicitly excluded. We retain the right for technical errors,
mistakes, changes and corrections without prior notice.
Installation of controlling devices should be done by an expert with suitable qualifi-
cation or by an authorised organisation. Before you deal with the main wiring, make
sure that the main switch is switched off.
You have to follow the rules for low-voltage installations IEC 60364 and VDE 0100,
law prescriptions for prevention of accidents, law prescriptions for environmental
protection and other national regulations.
Not following the rules this may lead to serious injuries such as burns or even risk of
death.

CONNECTION OF MAINS

All mains connection are made by means of built-in cables. Cable for power supply from
the network is equipped with schuko plug. Other power supply cable is intended for con-
nection of pump.

CONNECTION OF SENSORS, ROOM UNITS AND BUS

Layout of connectors is shown in picture.
GND
1
2
T1 / COM1
GND 3
COM1 4
GND 5
T2 / COM2 6
GND 7
8
T3
GND 9
T4
10
39
Installation manual