Service Settings Manual; Controller Parameters; Basic Parameters; Service Settings - Inocal PROMATIC CMP25-2 Bedienungsanleitung

CONTROLLER PARAMETERS

All additional settings and adjustments of controller performance are carried out by
means of parameters. Three groups of parameters are available.

Basic parameters

Service parameters
Floor drying parameters
Only those parameters that are used in the selected hydraulic scheme are
visible. From the selected hydraulic schemes depend also the factory setting
values of parameters.
BASIC PARAMETERS
The basic parameters are listed in groups P1 - basic settings, P2 - settings for heating
circuit, P3 - settings for heat sources.
Content of basic parameters is displayed as follows:
Parameter index
Setting range
Default parameter value
Parameter description
The desired parameter change is shown in the example below, for parameter P1.1.

Service settings manual

SERVICE SETTINGS MANUAL
Current parameter value
28