Fitting The Duct - De Dietrich HOTTE Betriebsanleitung

screws (2.3).
- Screw the fixing bracket (K) to the wall
with the two screws (D) (2.3.1).
- Attach the suction hood using the sus-
pension fittings.
- Adjust the height and level, using the
support adjustment screws (the top
screw for horizontal adjustment and the
lower screw for contact with the wall).
Caution: manually tighten without forcing
- Fit the locking screw that prevents the
appliance being lifted off the suspension
fittings (E).
- Remove the adhesive tape from the en-
closure
- Lift the enclosure approximately 2cm
and then release it, make it move a
quarter turn and then slide it and secure
it with the two screws (Q) on the front of
the motor.
Take care not to damage the cables du-
ring rotation and fixing.

2.4 - FITTING THE DUCT

•Evacuation outside
- Fix the metal duct support at ceiling
height, using the two screws (D/E).
- For a 125mm diameter duct, use the
adapter supplied (J).
If your duct to the outside is less than
125mm in diameter, you must connect
your hood in recycling mode.
- Push the end of the duct on to the motor
outlet.
- Prepare your telescopic duct, taking
care to hide the ears.
- Push the duct, assembled thus, on to
the hood and lift the upper part to adjust
the height and then screw it on to the
metal duct support using the two
screws (M).
• Recycling (optional kit - available
from after-sales service)
- Fix the plastic fume deflector (G)
against the wall at ceiling height with
the two screws. Take care to centre the
deflector with reference to the vertical
line (B) drawn on the wall.
Add the two spacers (P), supplied in the
product pouch, to the deflector.
- Push one end of the duct on to the de-
flector and the other end on to the
motor outlet.
- Prepare the duct, taking care to position
the ears at the top, so that they are vi-
sible (H).
- Push the duct, assembled thus, on to
the hood and lift the upper part to adjust
the height and then screw it on to the
fume deflector using the two screws
(M).
19