DeWalt DCN692 Übersetzt Von Den Originalanweisungen Seite 55

sYMPTOM CaUsE
Jammed nail Wrong size or angle nails
Magazine screws not secured after
previous jam clear/inspection
Damaged or worn driver blade
Material and fastener length
Debris in nosepiece
Worn magazine
Damaged pusher spring
Dry fire lock out is engaged with only 7–9
nails remaining in magazine and the user
is applying excessive force to contact trip,
overriding the lockout
Tool is not yet run-in
Use of incorrect speed.
FIX
Use only the recommended nails. Refer to Technical Data.
Make sure to tighten magazine hex bolts with wrench
provided.
Replace driver blade. See authorised D
If the unit continues to stall (forcing the need to rotate the
Stall release lever) choose the appropriate material and
fastener length that is not too rigorous an application.
Clean nose area and watch closely for small pieces of
broken nails stuck in the track.
Replace magazine. See authorised D
Replace spring. See authorised D
Load more nails in magazine to disengage dryfire lockout.
New tools can take 500–1000 nails for parts to mesh and
wear in together. Drive shorter nails during this period if
experiencing difficulty driving nails flush.
If trying to drive longer ring shank nails in soft woods, or
driving ring shank nails into harder materials in speed 1 -
adjust speed setting to position 2.
ENGLIsh
WALT repair agent.
e
WALT repair agent.
e
WALT repair agent.
e
53