Axkid Minikid Bedienungsanleitung Seite 7

Fastening The Vehicle Seat Belt
Open the belt lock-off clips (L) on both sides of the Minikid child restraint. Fully lengthen the
5
seat belt until the lap section of the belt is at least 70-80cm (27-32 inches) long. Feed the seat
belt through the seat belt slot (D), between the seat cover and seat body until the belt comes
out through the seat belt slot on the other side. If you prefer, you can instead feed the seat belt through
the seat belt slot (D), then over the top of the seat belt cover and then through the seat belt slot on the
other side.
Insert the seat belt tongue into the vehicle' s seat belt buckle. Pull the seat belt until all slack is
6
removed along the seat belt route. Secure both the lap and shoulder belt in the lock-off closest
to the vehicle' s seat belt buckle.
7
In the lock-off on the opposite side, only the lap belt should be secured.
Attaching The Tether Straps
Some vehicles may already be fitted with anchorage points at the base of the front seat rails, or, if
installing in the front passenger seat, in front of that seat.
If your vehicle does not have these anchor points, the supplied lower anchor straps must be
8
used.
For installation in the back seat, feed the buckle end of the anchor strap through either the rear
9
of the front seat rails, or the hinge of the front seat. The anchoring point needs to be as close
to the floor as possible. In doing so you should always insert the buckle of the anchor strap
through the closest appropriate slot in the strap to create a slip knot then pull tight. This needs to be
repeated on both sides to create two anchor points.
When installing Minikid in the front passenger seat the lower anchor straps must be attached
10
to the front gliding tracks so the anchor points will be located along the front edge of the
passenger seat.
11
Pull out the upper tether strap from the belt housing (K) to an appropriate length.
Check that the white marking on the strap (i) is visible. If not, you can try crossing the straps
12
over (ii) to give them some extra length to enable the white marking to be visible.
Clip the anchor attachments directly onto the vehicle anchorage points (or lower anchor straps
13
if you have used them). Press down hard on the top of one side (i) of the child restraint then
repeat on the other side (ii). When you do this it' s important that you really use your full body
weight to press down and get the tether straps to really tighten hard. This will give the tether straps
their first tightening.
6